Furlyn – Double sided pet grooming rake for shedding and mats

Finally, a brush that pulls the fur out.

You brush. You vacuum. You lint-roll. And somehow there's still fur everywhere.

The Furlyn changes that in one pass. One side has 9 wide teeth for breaking up mats. The other side has 17 fine curved teeth for pulling out the loose undercoat. No tugging. No pulling. Your pet stays calm — you just watch the fur come off.

Ready to use right out of the box. No setup, no learning curve.

A cold-season favorite for shedding breeds.

✓ Pulls out what other brushes miss
The 17 fine curved teeth reach deep into the undercoat and lift out the loose fur your regular brush glides right over. One pass shows more than a full grooming session.

✓ Breaks up mats without the pain
The 9 wide teeth on the flip side open up knots gently, so your pet doesn't flinch or pull away. Rounded tips protect the skin — no sharp edges, no yanking.

✓ One tool for every coat type
Works on long-haired dogs, curly poodles, thick double coats, and cats. Golden Retrievers, Huskies, Ragdolls, Maine Coons — same brush handles them all.

✓ Built to last through shedding seasons
Stainless steel blades stay sharp. The reinforced screw keeps the head from wobbling, and the soft grip handle stops your hand from cramping halfway through. 

What you get today

• Furlyn double-sided grooming rake
• 9 wide teeth for mats + 17 fine teeth for undercoat
• Ready to use — no setup
• Free tracked shipping
• 30-day at-home trial

Seasonal production run — once this batch sells out, restock pricing may change.

Get yours today and see the difference in one stroke — limited-time pricing.

Frequently asked questions

Is it safe for cats and small dogs?
Yes. The rounded tip design and skin-safe blade edges make it gentle enough for cats, kittens, and small breeds. Use light pressure and short strokes.

How often should I use it?
For heavy shedders, 2 to 3 times a week works well. For low-shed breeds, once a week is plenty. Don't over-brush — the coat needs some undercoat for insulation.

Will it work on a matted coat that's been left for a while?
Yes. Start with the 9-teeth side to gently break up the mat, then flip to the 17-teeth side to smooth the coat out. For severe mats, work in small sections.

How do I clean it after use?
Pull the loose fur off the teeth by hand or with a comb, then rinse the head under warm water and let it air dry. The stainless steel won't rust.

How to use

• Step 1: Start with the 9-teeth side. Run it gently through your pet's coat in the direction the fur grows to loosen mats and tangles.
• Step 2: Flip to the 17-teeth side. Stroke through the coat in short, light passes to pull out the loose undercoat.
• Step 3: Wipe or rinse the head clean when the fur builds up between the teeth.

Specifications

• Size: 7 inches long, 3 inches wide at the head
• Material: Stainless steel blades, soft ergonomic plastic handle
• Lasts: Built for years of regular use